Overview

• Mounting Holes
• I/O Connector Identification
• RF Connector Identification

Specifications

Sensor Cordinate System

Directions of sensors axes

The inertial frame is defined as a standard right-handed North, East, Down (NED) frame (X,Y,Z) as represented in the picture.

According to the “Right Hand Rule”, the rotations are positive clockwise in the axis direction as represented in the drawing below.

Origin of measurements

Because the QUANTA-Micro integrates several MEMS accelerometers, it integrates a built-in size effect compensation and as a result a ‘virtual’ reference point has been chosen to define the Origin of Measurements Point.

The origin of measurements, is the point where the inertial frame, as defined by the accelerometers triad, intersect. 

The Origin of Measurement Point is represented by the red target on the drawings below.

Mechanical Drawing

All dimensions are expressed in millimeters using the International System of Units (SI) conventions

• Figure : Sensor Coordinate Frame + IMU Center of Measurement
  
  • 3D ISO View
  • X/Y/Z Coordinate Frame
    
  • Top View, Center of Measurement
  • Bottom View Center of Measurement

CAD Models

• .STEP files : Product
  • External Shape / Skin of the product without internal details

Onboard connectors

Note : SBG-SYSTEMS could use other connectors while maintaining the correct match with the corresponding connectors listed below.

Mounting

Mounting solutions :

The product is designed to mount directly to a printed circuit board (PCB).

There are two recommended ways in which the product can be secured to the PCB :

• • The first method uses board mounted threaded standoffs
  • The second method uses common components

Board mounted threaded standoffs method

• Figure ( Gliffy Diagram :  Product_Mechanical_Integration_Solution-#1 ) : showing
  • Mounting view : product on base plate / PCB

Spacer and Nuts method

• Figure ( Gliffy Diagram :  Product_Mechanical_Integration_Solution-#2 ) : showing
  • Mounting view : product on base plate / PCB

Label

SBG Systems manufacturing process is based on EN-9100 system with individual and full traceability of every component and operation. Each unit is identified by a unique serial number that can be used to trace all operations during the product lifetime such as manufacturing, calibration, tests and repairs.

In addition to a unique serial number, a product code is used to define exactly the device type, options, configuration. You can find on the side of the product a laser printed label that hold all these identification information. This label also includes a data-matrix code that encodes the device unique serial number.

• Figure : Identification Label