Reusable Content Space
Page tree

Versions Compared

Old Version 2

changes.mady.by.user Vianney Ville

Saved on

compared with

New Version 3

changes.mady.by.user Vianney Ville

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
  • Overview
    • Mounting Holes
    • I/O Connector Identification
    • RF Connector Identification
  • Specification
    • Size
    • Weight
    • I/O Connector
      • Identification, Manufacturer, Manufacturer P/N, Description
    • RF Connector
      • Identification, Manufacturer, Manufacturer P/N, Description
    • Fastening
      • Recommended Fasteners
      • Recommended Torques : soft vs hard materials
    • Mechanical Dimensions
      • 2D drawing extracts
        • External dimensions
        • Mounting Holes
        • Location of connectors
      • Mounting view : product on base plate
      • Mounting solutions
        • The product is designed to mount directly to a printed circuit board (PCB).
        • There are two recommended ways in which the product can be secured to the PCB.
        • The first method uses board mounted threaded standoffs, and the second method uses an aluminum x-bracket. Both methods are shown in the diagram below.
      • Drawings
        • Data
          • Housing Materials
          • Finish/Surface Treament
          • Dimensions
          • Tolerances
          • IMU center of measurement
            • mark
            • IMU center of measurement is location at X/Y center frame symbol, Right handed coordinate system
          • Details Views
            • Internal Fastening solution
              • Thread Locker : Loctite
              • Screw Staked with: Hysol/Loctite EA - 0151
            • Mountning Hole Details View
              • Alignment / Locating holes
                • Hole on primary connetor side is circular. (Detail B)
                • Hole on auxiliary connector side is oval shape. (Detail C)
                • Recommended Locating/dowel pins : 3mm
              • Mounting Holes
                • Recommended mounting fasteners : ( M3 x 0.5 x 6-8mm [4-40 x 1/4] SOHC )
              • Grounding Points
                • Locations
                • Dimensions
                • Finish
                  • Passivated : SURTEC 650, ALODINE 1132
                  • Anodized
                    • Color
                    • Thickness
                  • Comments
                    • Anodization has been milled off the bottom surface of the four feet.
                    • Electrical resistivity of primary or auxiliary connector housing to surface of feet is less than 2.5 mOhm
                  • Connector Details Views
                    • Identification / Naming
                    • Notch / Pin Index location
                    • Pin arrangement & numbering
                  • Sensitive Components
                    • Type of component : Magnetometer
                    • Location
                    • Keepout areas

  • Sensor Cordinate System

    • Sensor Coordinate Frame
      • Figure : Sensor Coordinate Frame
        • 3D ISO View
        • X/Y/Z Coordinate Frame
      • IMU Center of Measurement
        • Figure : IMU Center of Measurement
          • Top View, Center of Measurement
          • Bottom View Center of Measurement